Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › from 2014.07
RM19S0E _56 Audio / Visual / Telematics _051484 NAVIGATION / MULTI INFO DISPLAY _0248277 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Illumination Circuit  


DESCRIPTION

Power is supplied to the navigation receiver assembly illumination when the light control switch is in the TAIL or HEAD position.

WIRING DIAGRAM

B378027E05
2.906,0.99 3.396,1.167 0.49,0.177 10 false PANEL 0.813,0.802 1.854,0.979 1.042,0.177 10 false from TAIL Relay 4.948,2.042 6.25,2.469 1.302,0.427 10 false Navigation Receiver Assembly 5.24,0.813 5.729,0.99 0.49,0.177 10 false ILL+ 4.948,1.854 5.438,2.031 0.49,0.177 10 false F130 4.958,0.719 5.167,0.896 0.208,0.177 10 false 10

CAUTION / NOTICE / HINT

CAUTION:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK ILLUMINATION
a.

Check if the illumination for the navigation receiver assembly or other parts (hazard switch, transmission control switch, etc.) comes on when the light control switch is turned to the head or tail position.

Result
Result Proceed to
Illumination comes on for all components except navigation receiver assembly A
No illumination comes on (navigation receiver assembly, hazard switch, heater control switch, etc.) B



A

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - BATTERY)

B

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - BATTERY)
a.
U158702E01
1.521,0.365 1.879,0.524 0.358,0.160 10 F130 0.026,0.021 0.319,0.181 0.294,0.160 10 *a 2.449,1.533 2.805,1.693 0.356,0.160 10 ILL+ 2.388,1.581 2.141,1.372 false

Disconnect the navigation receiver assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
F130-10 (ILL+) - Body ground Light control switch TAIL or HEAD 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Navigation Receiver Assembly)



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR