27020
1.INSTALL GENERATOR ASSEMBLY
Temporarily install the generator assembly with the fixing bolt.
Install the piping clamp with the bolt A and screw B.
Temporarily install the fan belt adjusting slider with fan belt adjusting slider fixing bolt A and nut B.
Move generator assembly toward the cylinder block and tighten nut B.
Connect the connector and engage the clamp.
Install the wire harness to terminal B with the nut.
Install the terminal cap.
16361A
2.INSTALL FAN AND GENERATOR V BELT
16361A
3.ADJUST FAN AND GENERATOR V BELT
16361A
4.INSPECT FAN AND GENERATOR V BELT
11212
5.INSTALL NO. 2 CYLINDER HEAD COVER
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL