27370
1.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY
Using a vernier caliper, measure the length of the exposed brushes.
| *a | Length |
9.5 to 11.5 mm (0.374 to 0.453 in.)
4.5 mm (0.177 in.)
If the exposed length is less than the minimum, replace the generator brush holder assembly.
27330
2.INSPECT GENERATOR ROTOR ASSEMBLY
Check the generator rotor assembly for an open circuit.
Measure the resistance according to the value(s) in the table below.
| *a | Slip Ring |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Slip ring - Slip ring | 20°C (68°F) | 1.85 to 2.25 Ω |
If the resistance is not as specified, replace the generator rotor assembly.
Check the generator rotor assembly for a short to ground.
Measure the resistance according to the value(s) in the table below.
| *a | Slip Ring |
| *b | Rotor Core |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Slip ring - Rotor core | Always | 10 MΩ or higher |
If the result is not as specified, replace the generator rotor assembly.
Check that the generator rotor bearing is not rough or worn and that it rotates smoothly.
If the generator rotor bearing does not rotate smoothly, replace the generator rotor assembly.
Using a vernier caliper, measure the slip ring diameter.
| *a | Diameter |
14.2 to 14.8 mm (0.559 to 0.583 in.)
14.0 mm (0.551 in.)
If the diameter is less than the minimum, replace the generator rotor assembly.
Check that the slip rings are not rough or scored.
If rough or scored, replace the generator rotor assembly.