Home › Power Source / Network › 1NZ-FE BATTERY / CHARGING › GENERATOR
RM19S0E _57 Power Source / Network _051486 1NZ-FE BATTERY / CHARGING _0248281 GENERATOR A

1NZ-FE BATTERY / CHARGING  GENERATOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 11212 3.REMOVE NO. 2 CYLINDER HEAD COVER

Hide 27020 5.REMOVE GENERATOR ASSEMBLY

A249989E02
2.823,0.49 2.146,1.083 true 2.833,0.344 3.021,0.573 0.188,0.229 10 true *1

a.

Remove the terminal cap.


b.

Disconnect the connector and the harness clamp.


c.

Remove the nut and disconnect the wire harness from terminal B.

Text in Illustration
*1 Terminal B


d.
A244005E02
1.75,1.625 1.906,1.802 0.156,0.177 10 false A 0.958,0.865 1.115,1.042 0.156,0.177 10 false B

Remove the belt adjusting slider fixing bolt A, nut B and the belt adjusting slider.


e.
A247897E03
2.063,1.406 2.292,1.635 0.229,0.229 10 true A 0.948,0.396 1.188,0.604 0.24,0.208 10 false B

Remove the bolt A, screw B and the piping clamp.


f.
A244006

Remove the fixing bolt and the generator assembly.