Home › Power Source / Network › 2NZ-FE BATTERY / CHARGING › GENERATOR › from 2014.07
RM19S0E _57 Power Source / Network _051487 2NZ-FE BATTERY / CHARGING _0248283 GENERATOR G

2NZ-FE BATTERY / CHARGING  GENERATOR  INSPECTION  


PROCEDURE

Hide 27370 1.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

a.
A310409E01
0.726,0.286 0.896,0.446 0.170,0.161 10 *a

Using a vernier caliper, measure the length of the exposed brushes.

Text in Illustration
*a Length

Standard exposed length:

9.5 to 11.5 mm (0.374 to 0.453 in.)


Minimum exposed length:

4.5 mm (0.177 in.)


If the exposed length is less than the minimum, replace the generator brush holder assembly.


Hide 27330 2.INSPECT GENERATOR ROTOR ASSEMBLY

a.
A310410E02
1.833,1.198 2.417,0.677 2.417,0.677 1.948,1.281 true 2.417,0.542 2.583,0.698 0.167,0.156 10 false *a

Check the generator rotor assembly for an open circuit.

i.

Measure the resistance according to the value(s) in the table below.

Text in Illustration
*a Slip Ring

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Slip ring 20°C (68°F) 1.85 to 2.25 Ω


If the resistance is not as specified, replace the generator rotor assembly.



b.
A310411E03
2.094,1.625 1.927,1.802 true 0.323,0.75 0.948,0.885 true 1.802,1.802 1.969,1.958 0.167,0.156 10 false *a 0.125,0.656 0.292,0.813 0.167,0.156 10 false *b

Check the generator rotor assembly for a short to ground.

i.

Measure the resistance according to the value(s) in the table below.

Text in Illustration
*a Slip Ring
*b Rotor Core

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Rotor core Always 10 MΩ or higher


If the result is not as specified, replace the generator rotor assembly.



c.
A310412

Check that the generator rotor bearing is not rough or worn and that it rotates smoothly.

If the generator rotor bearing does not rotate smoothly, replace the generator rotor assembly.


d.
A310413E01
0.517,0.63 0.687,0.790 0.170,0.161 10 *a

Using a vernier caliper, measure the slip ring diameter.

Text in Illustration
*a Diameter

Standard diameter:

14.2 to 14.8 mm (0.559 to 0.583 in.)


Minimum diameter:

14.0 mm (0.551 in.)


If the diameter is less than the minimum, replace the generator rotor assembly.


e.
A310414

Check that the slip rings are not rough or scored.

If rough or scored, replace the generator rotor assembly.