Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM(except Separate Type Yaw Rate Sensor) › 2011.08–2017.01
RM19S0E _57 Power Source / Network _051489 NETWORKING _0248285 CAN COMMUNICATION SYSTEM(except Separate Type Yaw Rate Sensor) L

NETWORKING  CAN COMMUNICATION SYSTEM(except Separate Type Yaw Rate Sensor)  PRECAUTION  


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


STEERING SYSTEM HANDLING PRECAUTIONS


a.

Care must be taken when replacing parts. Incorrect replacement could affect the performance of the steering system and result in hazards when driving.



SRS AIRBAG SYSTEM HANDLING PRECAUTIONS


a.

This vehicle is equipped with an SRS (Supplemental Restraint System), which includes components such as the driver airbag and front passenger airbag. Failure to carry out service operations in the correct sequence could cause unexpected SRS deployment during servicing and may lead to a serious accident. Before servicing (including installation/removal, inspection and replacement of parts), be sure to read the precautionary notice for the Supplemental Restraint System.




BUS LINE REPAIR


a.
E120441

After repairing the bus line with solder, wrap the repaired part with vinyl tape (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>ELECTRONIC CIRCUIT INSPECTION PROCEDURE).

NOTICE:
·

The CANL bus line and CANH bus line must be installed together.

·

When installing the CAN bus lines, be sure to twist them.

·

CAN bus lines are likely to be influenced by noise if the bus lines are not twisted together.

·

Leave approximately 80 mm (3.15 in.) loose in the twisted wires around the connectors.

·

When repairing the CAN bus lines, do not change the length of the lines. (Make sure that the length of the CANH bus line and CANL bus line are the same.)




b.
E134624E03
1.497,0.511 1.669,0.678 0.172,0.167 10 *1 1.707,0.605 1.85,0.605 1.85,0.605 2.053,1.03 false

Do not use by-pass wiring between the connectors.

NOTICE:

The protective effect of the twisted wire harness is lost if bypass wiring is used.


Text in Illustration
*1 By-pass Wire



CONNECTOR HANDLING


a.
E120443E02
1.068,1.521 1.273,1.688 0.205,0.168 10 *1 1.805,1.217 1.325,1.603 1.325,1.603 1.537,1.544 false

When inserting probes into a connector, insert them from the rear of the connector.

Text in Illustration
*1 Tester Probe


b.
E120444E02
1.979,0.515 2.162,0.680 0.183,0.164 10 *1 1.453,0.917 1.873,0.596 1.873,0.596 1.528,1.297 false 1.873,0.596 1.955,0.596 false

Use a repair wire to check the connector if it is impossible to check resistance from the rear of the connector.

Text in Illustration
*1 Repair Wire



PRECAUTIONS FOR INSPECTING OR REPLACING CAN JUNCTION CONNECTOR


a.

If the CAN junction connector is removed from the vehicle for inspection or replacement, make sure to install the CAN junction connector and all wire harnesses to their original locations with tape and the clamps.