After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
PRECAUTIONS WHEN USING INTELLIGENT TESTER
When using the intelligent tester to troubleshoot with the ignition switch off:
Connect the intelligent tester to the DLC3, and turn the courtesy light switch on and off at 1.5-second intervals until communication between the intelligent tester and vehicle begins.
After all DTCs are cleared, check if the trouble occurs again 6 seconds after the ignition switch to ON.