CHECK DLC3
Check the DLC3 (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>GENERAL INFORMATION).
INSPECT BATTERY VOLTAGE
Measure the battery voltage.
11 to 14 V
SELF-DIAGNOSTIC MODE (USING INTELLIGENT TESTER)
Switch to self-diagnostic mode.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter following menus: Body / Main Body / Utility / Wireless Door Lock Diagnosis Mode
Proceed to the next step in accordance with the prompts on the intelligent tester screen.
Check that the system has switched to self-diagnostic mode by checking the interior light output pattern.
Check the diagnostic outputs when the door control transmitter switch is held down. The diagnostic outputs can be checked by the interior light patterns.