84820
1.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (w/o Rear Power Window)
for LHD:
| *a | Component without harness connected
(Power Window Regulator Master Switch Assembly) |
| *b | LOCK |
| *c | UNLOCK |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 (L) - 7 (GND) | LOCK | Below 1 Ω |
| OFF | 10 kΩ or higher | |
| 9 (UL) - 7 (GND) | UNLOCK | Below 1 Ω |
| OFF | 10 kΩ or higher |
If the result is not as specified, replace the power window regulator master switch.
for RHD:
| *a | Component without harness connected
(Power Window Regulator Master Switch Assembly) |
| *b | LOCK |
| *c | UNLOCK |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (L) - 7 (GND) | LOCK | Below 1 Ω |
| OFF | 10 kΩ or higher | |
| 3 (UL) - 7 (GND) | UNLOCK | Below 1 Ω |
| OFF | 10 kΩ or higher |
If the result is not as specified, replace the power window regulator master switch.
84820
2.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (w/ Rear Power Window)
for LHD:
| *a | Component without harness connected
(Power Window Regulator Master Switch Assembly) |
| *b | LOCK |
| *c | UNLOCK |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (L) - 1 (GND) | LOCK | Below 1 Ω |
| OFF | 10 kΩ or higher | |
| 9 (UL) - 1 (GND) | UNLOCK | Below 1 Ω |
| OFF | 10 kΩ or higher |
If the result is not as specified, replace the power window regulator master switch.
for RHD:
| *a | Component without harness connected
(Power Window Regulator Master Switch Assembly) |
| *b | LOCK |
| *c | UNLOCK |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (L) - 9 (GND) | LOCK | Below 1 Ω |
| OFF | 10 kΩ or higher | |
| 8 (UL) - 9 (GND) | UNLOCK | Below 1 Ω |
| OFF | 10 kΩ or higher |
If the result is not as specified, replace the power window regulator master switch.
84930
3.INSPECT DOOR CONTROL SWITCH ASSEMBLY (w/o Power Window)
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected
(Door Control Switch Assembly) |
| *b | LOCK |
| *c | UNLOCK |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 4 (L) - 3 (E) | LOCK | Below 1 Ω |
| OFF | 10 kΩ or higher | |
| 2 (UL) - 3 (E) | UNLOCK | Below 1 Ω |
| OFF | 10 kΩ or higher |
If the result is not as specified, replace the door control switch.