Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK › from 2014.07
RM19S0E _58 Vehicle Interior _051490 DOOR LOCK _0248295 FRONT DOOR LOCK A

DOOR LOCK  FRONT DOOR LOCK  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the RH side.



PROCEDURE

Hide 69750C 1.INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY

a.

Engage the guide to Install the front door inside locking cable assembly to the front door lock assembly.


Hide 69710B 2.INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

a.

Engage the guide to install the front door lock remote control cable assembly to the front door lock assembly.


b.
B376047

Engage the 5 claws to close the cover.


Hide 69030A 3.INSTALL FRONT DOOR LOCK ASSEMBLY

NOTICE:
·

If reusing the front door lock assembly that has been removed, replace the door lock wire harness seal with a new seal.

·

Make sure that no grease or dirt adheres to the door lock wire harness seal surface.

·

Reusing the door lock wire harness seal or using a damaged door lock wire harness seal may cause water intrusion to the connection. This may result in a malfunction of the front door lock assembly.



a.

Apply MP grease to the sliding parts of the front door lock assembly.


b.

Install the door lock wire harness seal to the front door lock assembly.


c.
E221615E01
0.226,0.768 0.383,0.919 0.158,0.151 10 *1 0.432,0.861 1.246,0.7 false

Install the front door lock assembly to the front door lock open rod as shown in the illustration.

Text in Illustration
*1 Front Door Lock Open Rod

HINT:

Make sure that the front door lock open rod is securely connected to the front door lock assembly.



d.

Using a T30 "TORX" socket wrench, install the front door lock assembly with the 3 screws.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


e.

Connect the connector.


Hide 69217E 4.INSTALL FRONT DOOR OUTSIDE HANDLE COVER

a.

Apply MP grease to the sliding parts of the lock cylinder.


b.

Install the front door outside handle cover with lock cylinder.

NOTICE:

Check the engaging the lock cylinder to the front door lock assembly.



c.

Using a T30 "TORX" socket wrench, tighten the screw.

Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)


d.

Install the hole plug.


Hide 67403F 5.INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

Hide 68141C 6.INSTALL FRONT DOOR GLASS RUN

Hide 68101 7.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

Hide 67831 8.INSTALL FRONT DOOR SERVICE HOLE COVER

Hide 67601 9.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74231 10.INSTALL FRONT ARMREST BASE UPPER PANEL