When the communication line (IMI - EFIO) between the ECM and transponder key ECU assembly is stuck on HI output, the ECM stores this DTC.
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
|---|---|---|---|
| B279A | The communication line (IMI - EFIO) between the ECM and transponder key ECU assembly is stuck on HI output (1 trip detection logic*). | ·
Harness or connector ·
Transponder key ECU assembly ·
ECM |
Turn the ignition switch to ON and wait 6 seconds. |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Engine cannot be started (initial ignition occurs and engine cranks, then ignition stops) | Engine cannot be started |
| DTC Code | Data List and Active Test |
|---|---|
| B279A | - |
When replacing the transponder key ECU assembly, refer to the Service Bulletin.
When replacing the ECM, refer to the INITIALIZATION (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
Clear the DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
NEXT
Check for DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
DTC B279A is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Check that the connectors are properly connected to the ECM and transponder key amplifier assembly.
Connectors are properly connected.
OK
NG
Disconnect the F54 transponder key ECU assembly connector.
Disconnect the A74 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F54-13 (EFIO) - A74-11 (IMI) | Always | Below 1 Ω |
| F54-13 (EFIO) - Body ground | Always | 10 kΩ or higher |
OK
NG
Replace the transponder key ECU assembly (Refer to Service Bulletin).
NEXT
Register the key (Refer to Service Bulletin).
NEXT
Register the ECU communication ID (Refer to Service Bulletin).
NEXT
Check that the engine starts with the key.
Engine starts normally.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 2NZ-FE) | B |
| NG (for 1NZ-FE) | C |
A
B
C