CHECK ILLUMINATED ENTRY SYSTEM OPERATION
Perform this inspection with the customize parameters at the initial setting.
The operation and condition of this control are described below.
| Operation | Condition | Lighting |
|---|---|---|
| Fade in and illuminate constantly | Any door is opened when all the doors are closed. | Map Light Assembly |
| Illuminate for 15 seconds, and then fade out | When any of the following conditions is met:
·
The driver door is unlocked when the ignition switch is off and the driver door is closed and locked.*1 ·
The ignition switch is turned from ACC or ON to off when all doors are closed. ·
All the doors are closed when any door is opened and the ignition switch is off. |
|
| Fade out immediately | The ignition switch is turned from off to ACC or ON when all the doors are closed. | |
| The driver door is locked when the ignition switch is off, all the doors are closed and the driver door is unlocked.*1 | ||
| Battery Saving | When the doors remain in the same condition for 20 minutes and the key is not in the ignition key cylinder, the illumination turns off. |
*1: w/ Power Door Lock