Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM › from 2014.07
RM19S0E _58 Vehicle Interior _051492 LIGHTING (INT) _0248303 LIGHTING SYSTEM U

LIGHTING (INT)  LIGHTING SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Main Body / Data List.


e.

According to the display on the intelligent tester, read the Data List.

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
ACC SW Ignition switch ACC signal /
OFF or ON
OFF: Ignition switch off
ON: Ignition switch ACC or ON
-
IG SW Ignition switch ON signal /
OFF or ON
OFF: Ignition switch ACC or off
ON: Ignition switch ON
-
RR Door Courtesy SW*1 Rear door courtesy light switch LH and RH signal /
OFF or ON
OFF: Rear door LH and RH closed
ON: Rear door LH or RH opened
-
RL Door Courtesy SW*1 Rear door courtesy light switch LH and RH signal /
OFF or ON
OFF: Rear door LH and RH closed
ON: Rear door LH or RH opened
-
Back Door Courtesy SW Back door courtesy light switch signal /
OFF or ON
OFF: Back door closed
ON: Back door opened
-
FR Door Lock Pos*2*3 Front door unlock detection switch RH signal /
LOCK or UNLOCK
LOCK: Front door RH locked
UNLOCK: Front door RH unlocked
-
FR Door Courtesy Front door courtesy light switch RH signal /
ON or OFF
ON: Front door RH closed
OFF: Front door RH opened
-
FL Door Lock Pos*2*4 Front door unlock detection switch LH signal /
LOCK or UNLOCK
LOCK: Front door LH locked
UNLOCK: Front door LH unlocked
-
FL Door Courtesy Front door courtesy light switch LH signal /
ON or OFF
ON: Front door LH closed
OFF: Front door LH opened
-
RR-Door Lock Pos SW Not available /
OFF or ON
- -
RL-Door Lock Pos SW Not available /
OFF or ON
- -
I/L ON W/Door Key Unlock*5 Function which turns on interior lights when door is unlocked /
OFF or ON
Customized setting displayed -
Lighting Time*5 Lighting time after closing all doors /
15 s, 7.5 s or 30 s
Customized setting displayed -
I/L when ACC OFF*5 Function which turns on lights when ignition switch is turned from ACC to off /
OFF or ON
Customized setting displayed -

*1: for 5 Door

*2: w/ Power Door Lock

*3: for RHD

*4: for LHD

*5: w/ Automatic Light Control System




ACTIVE TEST


HINT:

Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Main Body / Active Test.


e.

According to the display on the intelligent tester, perform the Active Test.

Main Body
Tester Display Test Part Control Range Diagnostic Note
Illuminated Entry System Map light assembly OFF or ON Map light switch at DOOR position and all doors closed.