81260A
1.INSPECT MAP LIGHT ASSEMBLY
Apply battery voltage to the connector and check the map light comes on.
| *a | Component without harness connected
(Map Light Assembly) |
| Measurement Condition | Switch Condition | Specified Condition |
|---|---|---|
| Battery positive (+) → 3
Battery negative (-) → 1 |
All Switch off | All light not comes on |
| Battery positive (+) → 3
Battery negative (-) → 2 |
All Switch off | All light not comes on |
| Battery positive (+) → 3
Battery negative (-) → 1 |
Center Switch off
LH Side Switch on |
LH Side light comes on |
| Battery positive (+) → 3
Battery negative (-) → 1 |
Center Switch off
RH Side Switch on |
RH Side light comes on |
| Battery positive (+) → 3
Battery negative (-) → 1 |
LH Side Switch off
RH Side Switch off Center Switch on |
All light comes on |
| Battery positive (+) → 3
Battery negative (-) → 2 |
LH Side Switch off
RH Side Switch off Center Switch DOOR |
All light comes on |
If the result is not as specified, replace the map light blub or map light assembly.