81240
1.REMOVE NO. 1 ROOM LIGHT ASSEMBLY
Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws to remove the room light lens.
| *a | Protective Tape |
Using a screwdriver, disengage the 4 claws as shown in the illustration to separate the No. 1 room light housing.
| *a | Protective Tape |
Disengage the clamp to separate the wire harness.
Using a screwdriver, disengage the 4 claws to disconnect the room light switch base from the No. 1 room light housing.
2.REMOVE BULB
Remove the bulb from the room light switch base.