Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › from 2014.07
RM19S0E _58 Vehicle Interior _051493 METER / GAUGE / DISPLAY _0248310 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Entire Combination Meter does not Operate  


DESCRIPTION

This circuit is the power source circuit for the combination meter assembly.

WIRING DIAGRAM

E231156E09
4.958,3.021 5.219,3.188 0.26,0.167 10 false F1 3.417,1.469 3.792,1.656 0.375,0.188 10 false MET 3.146,0.813 4.063,1.031 0.917,0.219 10 false ECU-B NO. 2 5.365,0.604 5.833,0.823 0.469,0.219 10 false B 5.365,2.448 5.833,2.667 0.469,0.219 10 false ET 5.354,1.323 5.823,1.542 0.469,0.219 10 false IG+ 0.615,1.302 1.583,1.521 0.969,0.219 10 false from IG2 Relay 0.729,0.615 1.583,0.823 0.854,0.208 10 false from Battery 5.083,0.542 5.281,0.719 0.198,0.177 10 false 40 5.083,1.188 5.292,1.406 0.208,0.219 10 false 39 5.073,2.354 5.271,2.542 0.198,0.188 10 false 21 4.948,3.177 6.813,3.552 1.865,0.375 10 false Combination Meter Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - BATTERY AND BODY GROUND)
a.
U127304E01
1.641,0.073 1.829,0.229 0.188,0.156 10 F1 2.946,1.224 3.117,1.644 false 3.125,1.673 3.313,1.829 0.188,0.156 10 B 0.521,1.224 0.4,1.644 false 0.299,1.673 0.511,1.829 0.213,0.156 10 ET 2.768,1.224 2.751,1.644 false 2.632,1.673 2.921,1.829 0.289,0.156 10 IG+ 0.2,0.098 0.413,0.254 0.213,0.156 10 *a

Disconnect the F1 combination meter assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
F1-39 (IG+) - Body ground Ignition switch ON 11 to 14 V
F1-40 (B) - Body ground Always 11 to 14 V



c.

Measure the resistance according to the value in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F1-21 (ET) - Body ground Always Below 1 Ω


Text in Illustration
*a Front view of wire harness connector
(to Combination Meter Assembly)


d.

Reconnect the combination meter assembly connector.



OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR