Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › from 2014.07
RM19S0E _58 Vehicle Interior _051493 METER / GAUGE / DISPLAY _0248310 METER / GAUGE SYSTEM G

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT SPEEDOMETER

a.

Check speedometer operation.

NOTICE:
·

The meter ECU receives the vehicle speed signal from the skid control ECU via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the skid control ECU because it is the source of the vehicle speed signal.

·

The Data List values of the skid control ECU are used for this inspection. Therefore, make sure to perform the inspection after confirming that no DTCs are output from the brake control system.

·

If the tire size or tire inflation pressure is not within the specified range, or the tires are excessively worn, the speedometer indication error will increase. Therefore, make sure to perform the inspection after checking that the tire size, tire inflation pressure and tire wear are in the specified range.



i.

Before starting the following inspection, check if the Brake Control System outputs the DTCs.


ii.

Check the values by referring to the table below.

ABS/VSC/TRC
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Vehicle Speed Maximum wheel speed sensor reading/
Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)
Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations

Reference (km/h)
GTS Indication (km/h) Acceptable Range (km/h)
20 20.7 to 24.7
40 41.4 to 45.4
60 62.1 to 66.6
80 82.8 to 87.8
100 103.5 to 107.5
120 124.2 to 129.2
140 144.9 to 149.9
160 165.7 to 170.7
180 186.4 to 191.4
200 207.1 to 212.1



Hide 2.INSPECT TACHOMETER

a.

Check the operation.

i.

Connect the GTS, and start the engine.


ii.

Compare the test results with the tachometer indications.

Reference
GTS Indication (rpm) Acceptable Range (rpm)
Data in ( ) is for Reference
700 630 to 770
1000 (900 to 1100)
2000 (1850 to 2150)
3000 2800 to 3200
4000 (3800 to 4200)
5000 4800 to 5200
6000 (5750 to 6250)