Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).
45130
1.INSTALL STEERING PAD
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Connect the airbag connector.
| *1 | Locking Button |
Push in the locking button.
Do not damage the airbag wire harness when connecting the airbag connector.
Securely lock the locking button.
Connect the horn terminal.
Engage the 3 pins with the 3 snap rings to install the steering pad.
Pull the steering pad to ensure that it is securely engaged.
45186
2.INSTALL LOWER NO. 2 STEERING WHEEL COVER
Engage the 2 claws to install the lower No. 2 steering wheel cover.
3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4.INSPECT SRS WARNING LIGHT