Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY › 2014.07–2015.06
RM19S0E _58 Vehicle Interior _051495 SUPPLEMENTAL RESTRAINT SYSTEMS _0248319 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).


PROCEDURE

Hide 82142A 1.INSTALL NO. 2 INSTRUMENT PANEL WIRE

B282644E01
1.12,0.324 1.595,0.413 false 1.603,0.343 1.758,0.490 0.155,0.147 10 *1

a.

Connect the airbag connector to the No. 2 instrument panel wire.

Text in Illustration
*1 Locking Button


b.

Push in the locking button.

NOTICE:
·

Do not damage the airbag wire harness when connecting the airbag connector.

·

Securely lock the locking button.




Hide 73960A 2.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B285685E02
1.156,0.365 1.313,0.552 0.156,0.188 10 true A 1.656,1.625 1.802,1.813 0.146,0.188 10 true B 1.635,0.365 1.792,0.552 0.156,0.188 10 true A 2.125,0.365 2.281,0.552 0.156,0.188 10 true A 2.156,1.615 2.302,1.802 0.146,0.188 10 true B 1.156,1.615 1.302,1.802 0.146,0.188 10 true B

Engage the 3 hooks B.


d.

Engage the 3 hooks A to install the instrument panel passenger airbag assembly.


e.
B282641

Install the 2 screws


f.

Engage the 2 clamps.


Hide 55302A 4.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)