Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY › 2011.08–2016.09
RM19S0E _58 Vehicle Interior _051495 SUPPLEMENTAL RESTRAINT SYSTEMS _0248324 CENTER AIRBAG SENSOR ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CENTER AIRBAG SENSOR ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).


PROCEDURE

Hide 89170 1.INSTALL AIRBAG SENSOR ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
·

Check that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor assembly will cause the airbag to deploy.

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.




c.

Install the airbag sensor assembly with the 3 bolts.

Torque:
17.5 N*m (178 kgf*cm, 13 ft.*lbf)

NOTICE:
·

Do not use an airbag sensor assembly that has been dropped.

·

Do not subject the airbag sensor assembly to any impact or force.

·

Check that the carpet does not interfere with the installation plane.




d.

Check that there is no looseness by shaking the airbag sensor assembly.


e.
B271970E01
2.656,0.923 2.263,1.371 false 2.164,1.369 2.321,1.522 0.157,0.153 10 *1

Connect the connector holder to lock the lever.

NOTICE:

Check that the lever is locked.


Text in Illustration
*1 Lever


f.
B293918E01
0.701,0.874 0.359,0.712 false 0.195,0.625 0.376,0.787 0.181,0.162 10 *1

Check that the drip-proof sheet has not been removed and does not cut into the connectors.

Text in Illustration
*1 Drip-proof Sheet


Hide 58910C 2.INSTALL REAR CONSOLE BOX ASSEMBLY

Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

Hide 4. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION (for Built-in Type Yaw Rate Sensor)