Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM(w/ VSC/Separate Type Yaw Rate Sensor)
RM19S0E _58 Vehicle Interior _051495 SUPPLEMENTAL RESTRAINT SYSTEMS _0248330 AIRBAG SYSTEM(w/ VSC/Separate Type Yaw Rate Sensor) C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM(w/ VSC/Separate Type Yaw Rate Sensor)  B161B/1A  Front Center Airbag Sensor  


DESCRIPTION

The front airbag sensor consists of the diagnostic circuit and frontal deceleration sensor, etc.

If the airbag sensor assembly receives signals from the frontal deceleration sensor, it determines whether the SRS should be activated.

DTC B161B/1A is stored when a malfunction is detected in the front airbag sensor circuit.

DTC No. DTC Detection Condition Trouble Area
B161B/1A Either condition is met:
·

A front airbag sensor malfunction.

·

A airbag sensor assembly malfunction.


·

Front airbag sensor

·

Airbag sensor assembly



WIRING DIAGRAM

C234055E36
0.406,3.823 0.708,4 0.302,0.177 10 false A20 0.406,3.979 1.708,4.156 1.302,0.177 10 false Front Airbag Sensor 5.448,3.813 5.74,3.99 0.292,0.177 10 false F16 5.448,3.979 7.042,4.229 1.594,0.25 10 false Airbag Sensor Assembly 3.438,1.354 3.708,1.521 0.271,0.167 10 false AF1 3.427,2.521 3.719,2.698 0.292,0.177 10 false AF1 3.521,1.125 3.635,1.333 0.115,0.208 10 false 1 3.51,2.313 3.635,2.49 0.125,0.177 10 false 2 1.333,1.323 1.604,1.5 0.271,0.177 10 false +SL 1.365,2.5 1.625,2.708 0.26,0.208 10 false -SL 5.646,2.5 5.885,2.688 0.24,0.188 10 false -SL 5.646,1.323 5.927,1.51 0.281,0.188 10 false +SL 1.74,1.219 1.865,1.385 0.125,0.167 10 false 2 1.74,2.385 1.865,2.573 0.125,0.188 10 false 1 5.344,1.229 5.521,1.406 0.177,0.177 10 false 30 5.333,2.396 5.521,2.583 0.188,0.188 10 false 28

PROCEDURE

1.CHECK FRONT AIRBAG SENSOR
a.

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Temporarily replace the front airbag sensor with a new one.


d.

Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.


e.

Turn the ignition switch to ON, and wait for at least 60 seconds.



g.

Turn the ignition switch off.


h.

Turn the ignition switch to ON, and wait for at least 60 seconds.


i.

Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/ VSC/Separate Type Yaw Rate Sensor)>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC B161B/1A is not output A
DTC B161B/1A is output B

HINT:

Codes other than DTC B161B/1A may be output at this time, but they are not related to this check.



j.

Turn the ignition switch off.


k.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



l.

Reinstall the former front airbag sensor, and connect the connector.



A

END (FRONT AIRBAG SENSOR WAS DEFECTIVE)

B