Wear protective gloves. Sharp areas on the parts may injure your hands.
71077S
1.INSTALL SEPARATE TYPE REAR SEATBACK COVER
Using hog ring pliers, install the separate type rear seatback cover to the separate type rear seatback pad with 6 new hog rings.
| *1 | New Hog Ring |
| *2 | Hog Ring Pliers |
Do not soil or scratch the separate type rear seatback cover.
When installing hog rings, minimize wrinkles as much as possible.
72640A
2.INSTALL REAR SEATBACK LOCK ASSEMBLY LH
Install the rear seatback lock assembly LH with the 2 bolts.
71018
3.INSTALL REAR SEATBACK FRAME SUB-ASSEMBLY LH
Temporarily install the rear seatback frame sub-assembly LH.
Engage the 5 hooks.
Engage the 8 clips to install the rear seatback frame sub-assembly.
71931A
4.INSTALL REAR SEAT HEADREST SUPPORT
Align the protruding portion of the rear seat headrest support with the installation groove of the rear seatback frame sub-assembly LH.
| *a | protruding |
Engage the 8 claws to install the 4 rear seat headrest support.
72646
5.INSTALL REAR SEATBACK STOP BUTTON GROMMET
Engage the 2 claws to install the rear seatback stop button grommet.
72661C
6.INSTALL REAR SEATBACK LOCK RELEASE BUTTON
Turn the rear seatback lock release button in the direction indicated by arrow to install it.
72996A
7.INSTALL REAR SEATBACK COVER
Use the same procedure for both sides.
Engage the 4 claws to install the rear seatback cover.
71940A
8.INSTALL REAR SEAT HEADREST ASSEMBLY
Install the rear seat headrest assembly.
71960B
9.INSTALL REAR SEAT CENTER HEADREST ASSEMBLY
Install the rear seat center headrest assembly.
71075B
10.INSTALL BENCH TYPE REAR SEAT CUSHION COVER
Using hog ring pliers, install the bench type rear seat cushion cover to the bench type rear seat cushion pad with 44 new hog rings.
| *1 | New Hog Ring |
| *2 | Hog Ring Pliers |
Do not soil or scratch the bench type rear seat cushion cover.
When installing hog rings, minimize wrinkles as much as possible.