Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION). (w/ Front Seat Side Airbag)
Always use "TORX" socket wrench E10 when removing the front seat.
The procedure described below is for the LHD. Use the same procedure for both the RHD and LHD, unless otherwise specified.
73240
1.INSTALL FRONT SEAT INNER BELT ASSEMBLY
Install the front seat inner belt assembly with the bolt. (for 4 Way Seat Type)
Do not place the front seat inner belt over the convex areas of the front seat with frame adjuster.
| *a | Convex |
Engage the clamp. (for 4 Way Seat Type)
Install the front seat inner belt assembly with the bolt. (for 6 Way Seat Type)
Do not place the front seat inner belt over the convex areas of the front seat with frame adjuster.
| *a | Convex |
Engage the 2 clamps. (for 6 Way Seat Type)
Engage the 5 clamps.
Install the front seat cushion cover with the 4 clips. (for LHD)
2.INSTALL FRONT SEAT ASSEMBLY
3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)
4.INSPECT SRS WARNING LIGHT (w/ Front Seat Side Airbag)