Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY(for Front Passenger Side) › 2014.07–2015.06
RM19S0E _58 Vehicle Interior _051497 SEAT BELT _0248337 FRONT SEAT INNER BELT ASSEMBLY(for Front Passenger Side) A

SEAT BELT  FRONT SEAT INNER BELT ASSEMBLY(for Front Passenger Side)  INSTALLATION  


PROCEDURE

Hide 73230 1.INSTALL FRONT SEAT INNER BELT ASSEMBLY (w/o Wire Harness)

a.
B288295E02
1.787,2.795 2.288,3.025 2.288,3.025 2.024,2.683 false 2.259,3.033 2.430,3.197 0.170,0.164 10 *a

Install the front seat inner belt assembly with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)

NOTICE:

Do not place the front seat inner belt over the convex areas of the front seat with frame adjuster.


Text in Illustration
*a Convex


Hide 73230 2.INSTALL FRONT SEAT INNER BELT ASSEMBLY (w/ Wire Harness)

a.
B270851E05
2.125,2.854 2.792,2.948 2.792,2.948 1.979,2.948 false 2.813,2.854 3.083,3.052 0.271,0.198 10 false *a

Install the front seat inner belt assembly with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)

NOTICE:

Do not place the front seat inner belt over the convex areas of the front seat with frame adjuster.


Text in Illustration
*a Convex


b.

Engage the clamp.


c.

Install the 6 clamps.


d.

Connect the occupant detection sensor connector.


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).