Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY(for Front Passenger Side) › 2011.08–2016.09
RM19S0E _58 Vehicle Interior _051497 SEAT BELT _0248337 FRONT SEAT INNER BELT ASSEMBLY(for Front Passenger Side) A

SEAT BELT  FRONT SEAT INNER BELT ASSEMBLY(for Front Passenger Side)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION). (w/ Front Seat Side Airbag)


HINT:

The procedure described below is for the LHD. Use the same procedure for both the RHD and LHD, unless otherwise specified.


PROCEDURE

Hide 1. PRECAUTION (w/ Front Seat Side Airbag)

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 73230 4.REMOVE FRONT SEAT INNER BELT ASSEMBLY (w/ Wire Harness)

a.
B287108

Disconnect the occupant detection sensor connector.


b.

Remove the 6 clamps.


c.
B270847

Disengage the clamp.


d.

Remove the bolt and the front seat inner belt assembly.


Hide 73230 5.REMOVE FRONT SEAT INNER BELT ASSEMBLY (w/o Wire Harness)

a.
B288294

Remove the bolt and the front seat inner belt assembly.