Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY(for 5 Door) › 2014.07–2015.06
RM19S0E _58 Vehicle Interior _051497 SEAT BELT _0248338 FRONT SEAT OUTER BELT ASSEMBLY(for 5 Door) A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY(for 5 Door)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).


HINT:

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.


Hide 62311B 5.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

Hide 62331A 6.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

Hide 73210 7.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

a.
B273771

Disengage the 3 claws and remove the lap belt outer anchor cover.


b.
B272621

Remove the bolt and disconnect the floor anchor part of the front seat outer belt assembly.


Hide 73210 10.REMOVE FRONT SEAT OUTER BELT ASSEMBLY

a.
B271973

Remove the bolt and the shoulder anchor part of the front seat outer belt assembly.


b.
B272833E01
0.73,1.5 1.069,1.363 false 1.073,1.273 1.232,1.422 0.159,0.149 10 *1 0.536,1.54 0.302,1.997 false 0.173,1.99 0.344,2.148 0.171,0.158 10 *2

Using a screwdriver with its tip wrapped in protective tape, release the locking button.

Text in Illustration
*1 Protective Tape
*2 Locking Button


c.

Disconnect the pretensioner connector.


d.
B272835

Remove the 2 bolts.


e.

Disengage the 2 hooks and remove the front seat outer belt assembly.