Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.
67913
3.REMOVE FRONT DOOR SCUFF PLATE
67917A
4.REMOVE REAR DOOR SCUFF PLATE
62311B
5.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
62331A
6.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
73210
7.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY
Disengage the 3 claws and remove the lap belt outer anchor cover.
Remove the bolt and disconnect the floor anchor part of the front seat outer belt assembly.
62413A
8.REMOVE CENTER PILLAR LOWER GARNISH
62411B
9.REMOVE CENTER PILLAR UPPER GARNISH
73210
10.REMOVE FRONT SEAT OUTER BELT ASSEMBLY
Remove the bolt and the shoulder anchor part of the front seat outer belt assembly.
Using a screwdriver with its tip wrapped in protective tape, release the locking button.
| *1 | Protective Tape |
| *2 | Locking Button |
Disconnect the pretensioner connector.
Remove the 2 bolts.
Disengage the 2 hooks and remove the front seat outer belt assembly.