Home › Vehicle Interior › SEAT BELT › OCCUPANT DETECTION SENSOR › 2011.08–2016.09
RM19S0E _58 Vehicle Interior _051497 SEAT BELT _0248349 OCCUPANT DETECTION SENSOR A

SEAT BELT  OCCUPANT DETECTION SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:
·

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION). (w/ Front Seat Side Airbag)

·

Wear protective gloves. Sharp areas on the parts may injure your hands.



NOTICE:

Always use "TORX" socket wrench E10 when removing the front seat.


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 71512S 1.INSTALL SEPARATE TYPE FRONT SEAT CUSHION PAD

a.

Temporarily install the separate type front seat cushion cover.


b.
B272775E01
0.737,3.228 0.982,3.406 false 0.917,3.416 1.085,3.565 0.168,0.149 10 *1 1.813,4.238 2.058,4.415 false 1.993,4.426 2.161,4.575 0.168,0.149 10 *2

Using hog ring pliers, install 14 new hog rings.

NOTICE:
·

Be careful not to damage the separate type front seat cushion pad.

·

When installing the hog rings, take care to minimize wrinkles as much as possible.



Text in Illustration
*1 New Hog Ring
*2 Hog Ring Pliers


c.
B272773E01
0.753,3.261 0.997,3.425 false 0.934,3.43 1.083,3.581 0.148,0.151 10 *1 1.82,4.239 2.065,4.403 false 2.002,4.408 2.151,4.559 0.148,0.151 10 *2

Using hog ring pliers, install the separate type front seat cushion cover to the separate type front seat cushion pad with 2 new hog rings.

NOTICE:
·

Be careful not to damage the separate type front seat cushion pad.

·

When installing the hog rings, take care to minimize wrinkles as much as possible.



Text in Illustration
*1 New Hog Ring
*2 Hog Ring Pliers


Hide 2.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

Hide 72525A 5.INSTALL RECLINING ADJUSTER RELEASE HANDLE

Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)