The thermistor assembly (ambient temperature sensor) is installed in the front part of the cooler condenser assembly to detect the ambient temperature and control the air conditioner. The sensor connected to the air conditioning amplifier assembly detects fluctuations in the ambient temperature. This data is used for controlling the room temperature. The sensor sends a signal to the air conditioning amplifier assembly. The resistance of the thermistor assembly (ambient temperature sensor) changes in accordance with the cooler thermistor temperature (ambient temperature). As the temperature decreases, the resistance increases. As the temperature increases, the resistance decreases.
The air conditioning amplifier assembly applies a voltage (5 V) to the thermistor assembly (ambient temperature sensor) and reads voltage changes as changes in the resistance of the thermistor assembly (ambient temperature sensor).
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1412/12 | An open or short in the thermistor assembly (ambient temperature sensor) circuit. | ·
Thermistor assembly (ambient temperature sensor) ·
Harness or connector ·
Air conditioning amplifier assembly |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Air Conditioner / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Ambient Temp Sensor | Ambient temperature sensor /
Min.: -23.3°C (-9.94°F) Max.: 65.95°C (150.71°F) |
Actual ambient temperature is displayed | - |
The display is as specified in the normal condition column.
| Result | Proceed to |
|---|---|
| OK (When troubleshooting according to the DTC) | A |
| OK (When troubleshooting according to Problem Symptoms Table) | B |
| NG | C |
A
B
C
Check for DTCs (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>DTC CHECK / CLEAR).
DTC B1412/12 is not output
OK
NG
Inspect the thermistor assembly (ambient temperature sensor) (See page Vehicle Interior>HEATING / AIR CONDITIONING>AMBIENT TEMPERATURE SENSOR>INSPECTION).
OK
NG
Disconnect the A24 thermistor assembly (ambient temperature sensor) connector.
Disconnect the F42 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A24-2 - F42-5 (TAM) | Always | Below 1 Ω |
| A24-1 - F42-13 (SG-2) | Always | Below 1 Ω |
| A24-2 - Body ground | Always | 10 kΩ or higher |
| A24-1 - Body ground | Always | 10 kΩ or higher |
OK
NG