Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)
RM19S0E _58 Vehicle Interior _051498 HEATING / AIR CONDITIONING _0248350 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  Back-up Power Source Circuit  


DESCRIPTION

The back-up power source circuit for the air conditioning amplifier assembly is shown below. Power is supplied even after the ignition switch is turned off and is used for diagnostic trouble code memory, etc.

WIRING DIAGRAM

E228247E01
0.675,1.045 1.463,1.208 0.788,0.163 10 from Battery 2.49,1.194 3.361,1.357 0.871,0.163 10 ECU-B NO. 2 4.458,0.97 4.644,1.119 0.185,0.149 10 21 4.746,1.042 4.888,1.212 0.142,0.170 10 B 4.269,1.972 4.545,2.109 0.276,0.137 10 F42 4.269,2.133 6.501,2.303 2.232,0.170 10 Air Conditioning Amplifier Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BATTERY)
U158643E01
1.599,0.191 1.855,0.373 0.256,0.181 10 F42 0.1,0.061 0.270,0.222 0.170,0.161 10 *a 0.184,1.794 0.299,1.950 0.114,0.156 10 B 0.365,1.385 0.244,1.776 false

a.

Disconnect the F42 air conditioning amplifier assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F42-21 (B) - Body ground Always 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Air Conditioning Amplifier Assembly)



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR