The air conditioning control assembly communicates with the air conditioning amplifier assembly through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate even if the air conditioning control assembly is operated.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B14B2 | Lost communication with the air conditioning control assembly. | ·
LIN communication system ·
Air conditioning control assembly ·
Air conditioning amplifier assembly |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the F40 air conditioning control assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F40-5 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector
(to Air Conditioning Amplifier Assembly) |
OK
NG
Disconnect the F40 air conditioning control assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F40-8 (GND) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to Air Conditioning Amplifier Assembly) |
OK
NG
Disconnect the F40 air conditioning control assembly connector.
Disconnect the F42 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F40-3 (LIN1) - F42-37 (LIN1) | Always | Below 1 Ω |
| F40-3 (LIN1) - Body ground | Always | 10 kΩ or higher |
OK
NG
Replace the air conditioning control assembly with a new or normally functioning one (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING PANEL(for Automatic Air Conditioning System)>REMOVAL).
NEXT
Check for DTCs (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>DTC CHECK / CLEAR).
DTC B14B2 is not output
OK
NG