Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Manual Air Conditioning System) › from 2015.06
RM19S0E _58 Vehicle Interior _051498 HEATING / AIR CONDITIONING _0248351 AIR CONDITIONING SYSTEM(for Manual Air Conditioning System) C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)  B1413  Evaporator Temperature Sensor Circuit  


DESCRIPTION

The No. 1 cooler thermistor (evaporator temperature sensor) is installed on the evaporator in the air conditioning unit to detect the temperature of the cooled air that has passed through the evaporator and control the air conditioning. It sends appropriate signals to the air conditioning amplifier assembly. The resistance of the No. 1 cooler thermistor (evaporator temperature sensor) changes in accordance with the temperature of the cooled air that has passed through the evaporator. As the temperature decreases, the resistance increases. As the temperature increases, the resistance decreases.

The air conditioning amplifier assembly applies voltage (5 V) to the No. 1 cooler thermistor (evaporator temperature sensor) and reads voltage changes as the resistance of the No. 1 cooler thermistor (evaporator temperature sensor) changes. This sensor is used for frost prevention.

DTC No. DTC Detection Condition Trouble Area
B1413 An open or short in the No. 1 cooler thermistor (evaporator temperature sensor) circuit.
·

No. 1 cooler thermistor (evaporator temperature sensor)

·

Harness or connector

·

Air conditioning amplifier assembly



WIRING DIAGRAM

E346167E01
2.448,0.781 2.583,0.969 0.135,0.188 10 false 2 2.448,1.198 2.583,1.385 0.135,0.188 10 false 1 5.01,0.792 5.146,0.979 0.135,0.188 10 false 4 4.958,1.167 5.125,1.354 0.167,0.188 10 false 15 0.948,1.854 1.219,2.042 0.271,0.188 10 false F32 0.948,2.021 2.958,2.396 2.01,0.375 10 false No. 1 Cooler Thermistor (Evaporator Temperature Sensor) 4.677,2.094 4.948,2.281 0.271,0.188 10 false F41 4.677,2.281 6.865,2.49 2.188,0.208 10 false Air Conditioning Amplifier Assembly 5.271,0.917 5.458,1.083 0.188,0.167 10 false TE 5.25,1.292 5.615,1.469 0.365,0.177 10 false SG-1

PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Air Conditioner / Data List.


e.

According to the display on the intelligent tester, read the Data List.

Air Conditioner
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Evaporator Fin Thermistor Evaporator temperature sensor/
Min.: -29.7°C (-21.46°F)
Max.: 59.55°C (139.19°F)
Actual evaporator temperature displayed Open in the circuit: -29.7°C (-21.46°F).
Short in the circuit: 59.55°C (139.19°F).

OK:

The display is as specified in the normal condition column.


Result
Result Proceed to
OK (When troubleshooting according to the DTC) A
OK (When troubleshooting according to Problem Symptoms Table) B
NG C



A

2.CHECK FOR DTC

B

C

3.INSPECT NO. 1 COOLER THERMISTOR (EVAPORATOR TEMPERATURE SENSOR)
3.INSPECT NO. 1 COOLER THERMISTOR (EVAPORATOR TEMPERATURE SENSOR)
a.

Inspect the No. 1 cooler thermistor (evaporator temperature sensor) (See page Vehicle Interior>HEATING / AIR CONDITIONING>FRONT EVAPORATOR TEMPERATURE SENSOR>INSPECTION).



OK

4.CHECK HARNESS AND CONNECTOR (NO. 1 COOLER THERMISTOR (EVAPORATOR TEMPERATURE SENSOR) - AIR CONDITIONING AMPLIFIER ASSEMBLY)

NG

REPLACE NO. 1 COOLER THERMISTOR (EVAPORATOR TEMPERATURE SENSOR)

4.CHECK HARNESS AND CONNECTOR (NO. 1 COOLER THERMISTOR (EVAPORATOR TEMPERATURE SENSOR) - AIR CONDITIONING AMPLIFIER ASSEMBLY)
a.

Disconnect the F32 No. 1 cooler thermistor (evaporator temperature sensor) connector.


b.

Disconnect the F41 air conditioning amplifier assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F32-2 - F41-4 (TE) Always Below 1 Ω
F32-1 - F41-15 (SG-1) Always Below 1 Ω
F32-2 - Body ground Always 10 kΩ or higher
F32-1 - Body ground Always 10 kΩ or higher




OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR