Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)
RM19S0E _58 Vehicle Interior _051498 HEATING / AIR CONDITIONING _0248351 AIR CONDITIONING SYSTEM(for Manual Air Conditioning System) C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)  B14B8  Refrigerant Shortage  


SYSTEM DESCRIPTION

This DTC is stored if the refrigerant is insufficient in the cycle.

The air conditioning amplifier assembly receives the ambient temperature signal, refrigerant pressure signal etc. from the various sensors.

Based on these signals, the air conditioning amplifier assembly detects the amount of refrigerant.

The A/C switch indicator is turned off and air conditioning system is stopped if the amount of refrigerant is insufficient in the cycle.

DTC No. DTC Detection Condition Trouble Area
B14B8 When the following conditions is detected using the refrigerant shortage check in normal operation:
The amount of refrigerant is insufficient.
·

Refrigerant pipe line

·

Cooler expansion valve

·

Air conditioning amplifier assembly



PROCEDURE

1.CHECK FOR AIR CONDITIONING SYSTEM LEAK
a.

Install a manifold gauge set.


b.

Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.


c.

Evacuate the air conditioning system and check that vacuum can be maintained in it.

OK:

Vacuum can be maintained in the air conditioning system.


HINT:

If vacuum cannot be maintained in the air conditioning system, refrigerant may be leaking from it. In this case, it is necessary to repair or replace the leaking part of the air conditioning system.


Result
Result Proceed to
NG A
OK B



A

2.REPAIR AIR CONDITIONING SYSTEM LEAK

B

3.CHARGE REFRIGERANT
2.REPAIR AIR CONDITIONING SYSTEM LEAK
a.

Identify the area where refrigerant leaks (See page Vehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT>ON-VEHICLE INSPECTION).


b.

Repair the identified area of the air conditioning system.


c.

Evacuate the air conditioning system.



NEXT

3.CHARGE REFRIGERANT
3.CHARGE REFRIGERANT
a.

Add an appropriate amount of refrigerant (See page Vehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT>REPLACEMENT).



NEXT

4.CHECK FOR DTC
4.CHECK FOR DTC
a.

Check for DTCs when the following conditions are met (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)>DTC CHECK / CLEAR).

Measurement Condition
Item Condition
A/C Switch*1 ON
Temperature Setting*2 COOL ON
A/C Driving Time 15 minutes or more
Ambient Temperature 0 to 49°C (32 to 120°F)
Engine Coolant Temperature 45°C (113°F) or more

*1: w/ Heater

*2: w/o Heater


Result
Result Proceed to
NG A
OK B



A

5.REPLACE COOLER EXPANSION VALVE

B

END

5.REPLACE COOLER EXPANSION VALVE
a.

Replace the cooler expansion valve with a new or normally functioning one (See page Vehicle Interior>HEATING / AIR CONDITIONING>COOLER EXPANSION VALVE>REMOVAL).

HINT:

Replace the cooler expansion valve with a new or normally functioning one because the cooler expansion valve is either stuck or clogged.




NEXT

6.CHARGE REFRIGERANT
6.CHARGE REFRIGERANT
a.

Add an appropriate amount of refrigerant (See page Vehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT>REPLACEMENT).



NEXT

7.CHECK FOR DTC
7.CHECK FOR DTC
a.

Check for DTCs when the following conditions are met (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)>DTC CHECK / CLEAR).

Measurement Condition
Item Condition
A/C Switch*1 ON
Temperature Setting*2 COOL ON
A/C Driving Time 15 minutes or more
Ambient Temperature 0 to 49°C (32 to 120°F)
Engine Coolant Temperature 45°C (113°F) or more

*1: w/ Heater

*2: w/o Heater


Result
Result Proceed to
NG A
OK B



A

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

B

END