Home › Vehicle Interior › HEATING / AIR CONDITIONING › REFRIGERANT LINE
RM19S0E _58 Vehicle Interior _051498 HEATING / AIR CONDITIONING _0248352 REFRIGERANT LINE A

HEATING / AIR CONDITIONING  REFRIGERANT LINE  INSTALLATION  


PROCEDURE

Hide 1.INSTALL PIPING CLAMP

a.
I103971E03
1.76,0.635 1.958,0.448 false 1.49,0.781 1.125,0.396 true 0.969,1.521 0.969,1.74 false 2,0.302 2.177,0.469 0.177,0.167 10 false *1 0.927,0.271 1.104,0.438 0.177,0.167 10 false *2 0.875,1.76 1.052,1.927 0.177,0.167 10 false *3

Install a new piping clamp onto the suction hose.

Text in Illustration
*1 Piping Clamp
*2 Groove
*3 Suction Hose

NOTICE:

Securely engage the inside step of the piping clamp in the suction hose groove.



b.

Remove the vinyl tape from the open ends of the suction tube and suction hose.


c.

Thoroughly coat a new O-ring and the contact surface of the suction hose with compressor oil (ND-OIL8).


d.

Install the 2 O-rings onto the suction hose.

NOTICE:

Do not let foreign matter adhere to the O-ring or O-ring seal.



e.
I103972E06
0.781,1.75 1.083,1.146 true 2.292,1.833 2.292,2.354 true 0.438,1.865 0.438,2.271 false 1.104,1.042 1.281,1.208 0.177,0.167 10 false *1 0.344,2.292 0.531,2.469 0.188,0.177 10 false *2 2.198,2.365 2.417,2.542 0.219,0.177 10 false *3

Engage the suction tube and suction hose by matching the alignment marks.

Text in Illustration
*1 Large Diameter Section of Piping Clamp
*2 Alignment Mark
*3 Alignment Mark (yellow)

NOTICE:

Insert them by holding the pipe, not the piping clamp.



f.
I103973E01
0.85,0.326 1.020,0.508 0.170,0.183 10 *1 1.386,0.82 1.039,0.431 false

Securely insert the piping clamp to the point where the large diameter section of the piping clamp is covered by the suction tube.

Text in Illustration
*1 Large Diameter Section of Piping Clamp

HINT:
·

When inserting, make sure that a click sound is heard.

·

Check that the suction tube is securely inserted by pulling it.