87201
1.REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY
Disengage the 2 claws and 2 guides, and remove the air duct.
87130K
2.REMOVE NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)
Remove the 2 screws and the blower damper servo.
55908A
3.REMOVE AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)
Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the air inlet damper control cable.
| *1 | Protective Tape |
88648P
4.REMOVE NO. 1 AIR CONDITIONING WIRE (for LHD Automatic Air Conditioning System)
Disconnect the connector.
Disengage the 3 clamps and remove the air conditioning wire.
87103B
5.REMOVE BLOWER MOTOR WITH FAN SUB-ASSEMBLY
Remove the 3 screws and the blower motor.
87165C
6.REMOVE BLOWER MOTOR CONTROL (for LHD Automatic Air Conditioning System)
Remove the 2 screws and the blower motor control.
87138C
7.REMOVE BLOWER RESISTOR (for Manual Air Conditioning System)
Remove the 2 screws and the blower resistor.
88548B
8.REMOVE AIR FILTER CASE
Pinch portion A to disengage the claw and remove the air filter case.
87139C
9.REMOVE CLEAN AIR FILTER
Remove the clean air filter from the blower.