1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
16361A
2.REMOVE FAN AND GENERATOR V BELT
51441C
3.REMOVE ENGINE UNDER COVER RH (for Plastic Type)
51405A
4.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type)
88704
5.DISCONNECT SUCTION HOSE SUB-ASSEMBLY (w/o Fan Shroud Ventilation Duct)
Remove the bolt and disconnect the suction hose from the compressor.
Remove the O-ring from the suction hose.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
88704
6.DISCONNECT SUCTION HOSE SUB-ASSEMBLY (w/ Fan Shroud Ventilation Duct)
Remove the bolt and disconnect the suction hose from the compressor.
Remove the O-ring from the suction hose.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
88711
7.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE (w/o Fan Shroud Ventilation Duct)
Remove the bolt and disconnect the discharge hose from the compressor.
Remove the O-ring from the discharge hose.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
88711
8.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE (w/ Fan Shroud Ventilation Duct)
Remove the bolt and disconnect the discharge hose from the compressor.
Remove the O-ring from the discharge hose.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
88310
9.REMOVE COMPRESSOR WITH PULLEY ASSEMBLY
Disconnect the connector.
Remove the 4 bolts and the compressor.