Home › Vehicle Interior › HEATING / AIR CONDITIONING › CONDENSER › 2011.08–2017.01
RM19S0E _58 Vehicle Interior _051498 HEATING / AIR CONDITIONING _0248360 CONDENSER A

HEATING / AIR CONDITIONING  CONDENSER  INSTALLATION  


PROCEDURE

Hide 88460 1.INSTALL COOLER CONDENSER ASSEMBLY

a.

Engage the 2 claws, 2 guides and install the cooler condenser into the vehicle.

NOTICE:

Do not damage the condenser or radiator when installing the condenser.


HINT:

If a new cooler condenser is installed, add compressor oil to the condenser as follows.


Capacity:

Add 40 cc (1.35 fl. oz.)


Compressor oil:

ND-OIL8 or equivalent.



Hide 88706A 2.CONNECT LIQUID TUBE SUB-ASSEMBLY A (w/o Fan Shroud Ventilation Duct)

a.

Remove the attached vinyl tape from the tube and the connecting part of the cooler condenser.


b.

Apply sufficient compressor oil to a new O-ring and the fitting surface of the tube joint.

Compressor oil:

ND-OIL8 or equivalent.



c.

Install the O-ring onto the liquid tube.


d.

Install the liquid tube onto the cooler condenser with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 88706B 3.CONNECT LIQUID TUBE SUB-ASSEMBLY B (w/ Fan Shroud Ventilation Duct)

a.

Remove the attached vinyl tape from the tube and the connecting part of the cooler condenser.


b.

Apply sufficient compressor oil to a new O-ring and the fitting surface of the tube joint.

Compressor oil:

ND-OIL8 or equivalent.



c.

Install the O-ring onto the liquid tube.


d.

Install the liquid tube onto the cooler condenser with the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 4.INSTALL AIR DUCT (w/ Fan Shroud Ventilation Duct)

a.

Engage the 4 claws and install the fan shroud ventilation duct.


Hide 88711 5.CONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

a.

Remove the attached vinyl tape from the hose and the connecting part of the cooler condenser.


b.

Apply sufficient compressor oil to a new O-ring and the fitting surface of the hose joint.

Compressor oil:

ND-OIL8 or equivalent.



c.

Install the O-ring onto the discharge hose.


d.

Install the discharge hose onto the cooler condenser with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 88891H 6.INSTALL NO. 1 COOLER COVER

a.

Engage the 2 guides and install the cooler cover.


Hide 53205 7.INSTALL RADIATOR UPPER SUPPORT SUB-ASSEMBLY

a.

Install the radiator upper support with the 4 bolts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


b.

Engage the 2 clamps and install the hood lock control cable.


c.

Engage the 2 clamps and install the wire harness.


d.

Connect the connector.


e.

Install the 2 clips.


Hide 81150 9.INSTALL HEADLIGHT ASSEMBLY LH

Hide 81110 10.INSTALL HEADLIGHT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.