1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
81150
2.REMOVE HEADLIGHT ASSEMBLY LH
81110
3.REMOVE HEADLIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
89173
4.REMOVE FRONT AIRBAG SENSOR
53205
5.REMOVE RADIATOR UPPER SUPPORT SUB-ASSEMBLY
Remove the 2 clips.
Disconnect the connector.
Disengage the 2 clamps and disconnect the wire harness.
Disengage the 2 clamps and disconnect the hood lock control cable.
Remove the 4 bolts and the radiator support.
88891H
6.REMOVE NO. 1 COOLER COVER
Disengage the 2 guides and remove the cooler cover.
88711
7.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
Remove the bolt and disconnect the cooler refrigerant discharge hose from the cooler condenser
| *A | w/o Fan Shroud Ventilation Duct |
| *B | w/ Fan Shroud Ventilation Duct |
Remove the O-ring from the cooler refrigerant discharge hose.
Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.
8.REMOVE AIR DUCT (w/ Fan Shroud Ventilation Duct)
Disengage the 4 claws and remove the fan shroud ventilation duct from the cooler condenser.
88706A
9.DISCONNECT LIQUID TUBE SUB-ASSEMBLY A (w/o Fan Shroud Ventilation Duct)
Remove the bolt and disconnect the liquid tube from the cooler condenser.
Remove the O-ring from the liquid tube
Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.
88706B
10.DISCONNECT LIQUID TUBE SUB-ASSEMBLY B (w/ Fan Shroud Ventilation Duct)
Remove the 2 bolts and disconnect the liquid tube from the cooler condenser.
Remove the O-ring from the liquid tube
Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.
88460
11.REMOVE COOLER CONDENSER ASSEMBLY
Disengage the 2 claws.
Disengage the 2 guides and remove the cooler condenser.
Do not damage the condenser or radiator when removing the cooler condenser.