1.INSTALL INSTRUMENT PANEL CUSHION
for Lower Side:
Peel off the backing paper from the double-sided tape before installing the instrument panel cushion.
Install a new instrument panel cushion as shown in the illustration.
for Upper Side:
Peel off the backing paper from the double-sided tape before installing the instrument panel cushion.
Install a new instrument panel cushion as shown in the illustration.
Fold down the excess length on the left and right sides.
for Front Passenger Side:
Peel off the backing paper from the double-sided tape before installing the 3 instrument panel cushions.
Install 3 new instrument panel cushions as shown in the illustration.
for Center:
Peel off the backing paper from the double-sided tape before installing the instrument panel cushion.
Install a new instrument panel cushion as shown in the illustration.
for Driver Side:
Peel off the backing paper from the double-sided tape before installing the instrument panel cushion.
Install a new instrument panel cushion as shown in the illustration.
55961
2.INSTALL NO. 1 SIDE DEFROSTER NOZZLE
Engage the guide and 4 claws to install the No. 1 side defroster nozzle.
55441
3.INSTALL INSTRUMENT PANEL BOX
Engage the 4 guides to install the instrument panel box.
Install the 4 <A> screws.
73960A
4.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
55670A
5.INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY
Engage the 6 guides to center instrument panel register assembly.
Install the 6 <A> screws.
55840C
6.INSTALL NO. 6 HEATER TO REGISTER DUCT ASSEMBLY
Install the No. 6 heater to register duct assembly.
55844
7.INSTALL NO. 2 HEATER TO REGISTER DUCT
Engage the 3 guides to No. 2 heater to register duct.
| *a | Wire Harness |
| *b | Guide |
Install the 4 <A> screws.
Engage the wire harness clamp.
55843A
8.INSTALL NO. 1 HEATER TO REGISTER DUCT
Engage the 4 guides to No. 1 heater to register duct.
Install the 4 <A> screws.
55650
9.INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY
Engage the 3 claws to install the No. 1 instrument panel register assembly.
55404D
10.INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Engage the 4 clips to install the instrument cluster finish panel subassembly.