84810
1.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected
(Power Window Regulator Switch Assembly) |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 4(U) - 3(B)
2(SD) - 1(D) |
UP | Below 1 Ω |
| 5(SU) - 4(U)
2(SD) - 1(D) |
OFF | Below 1 Ω |
| 5(SU) - 4(U)
3(B) - 1(D) |
DOWN | Below 1 Ω |
If the result is not as specified, replace the power window regulator switch assembly.