Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM19S0E _59 Vehicle Exterior _051501 WINDOW / GLASS _0248389 POWER WINDOW CONTROL SYSTEM C

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  B2311  Power Window Motor Malfunction  


DESCRIPTION

The power window regulator motor is operated by the power window regulator master switch assembly. The power window regulator motor assembly LH or RH (driver side) has motor, regulator and ECU functions.

This DTC is output when the power window regulator motor assembly LH or RH (driver side) has a malfunction, or the ECU built into the regulator motor assembly determines that the fully closed window position has deviated approximately 20 mm (0.787 in.) or more from the normal position.

DTC No. DTC Detection Condition Trouble Area
B2311

Either condition is met:

(a)

Power window regulator motor assembly LH or RH (driver side) malfunctions

(b)

When ECU in power window regulator motor assembly LH or RH (driver side) determines that fully closed window position has deviated approx. 20 mm (0.787 in.) or more from normal position



·

Power window regulator motor assembly LH or RH (driver side)

·

Incorrect installation of power window components



CAUTION / NOTICE / HINT

NOTICE:
·

When the power window regulator motor assembly LH or RH (driver side) is reinstalled or replaced, the power window control system must be initialized.

·

After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be resumed by repeating the following operations at least 5 times:

(a)

Close the power window by fully pulling up the power window regulator master switch assembly and holding it in the auto up position.

(b)

Open the power window by fully pushing down the power window regulator master switch assembly.




PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / D-Door Motor / Active Test.


e.

According to the display on the intelligent tester, perform the Active Test.

CAUTION:

Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function will not operate.


D-Door Motor
Tester Display Test Part Control Range Diagnostic Note
Power Window Power window OFF / DOWN / UP -

OK:

Driver side power window motor operates.




OK

2.PERFORM INITIALIZATION (DRIVER SIDE)

NG

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH OR RH (DRIVER SIDE)

2.PERFORM INITIALIZATION (DRIVER SIDE)
a.

Initialize the power window regulator motor assembly LH or RH (driver side) (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).


b.

Check that power window regulator motor assembly LH or RH (driver side) operates normally by opening and closing the window (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).

OK:

Power window regulator motor assembly LH or RH (driver side) operates normally.




OK

3.CHECK WHETHER PARTS HAVE BEEN INSTALLED CORRECTLY

NG

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH OR RH (DRIVER SIDE)

3.CHECK WHETHER PARTS HAVE BEEN INSTALLED CORRECTLY
a.

Check that the power window components are installed correctly.

OK:

Driver side power window components are installed correctly.


HINT:

When the power window components are installed correctly, the problem has occurred because, the power window components are installed improperly or the motor is overheated.




OK

END

NG

INSTALL PARTS CORRECTLY