Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR
RM19S0E _59 Vehicle Exterior _051502 DOOR / HATCH _0248394 BACK DOOR G

DOOR / HATCH  BACK DOOR  INSPECTION  


PROCEDURE

Hide 84903B 1.INSPECT DOOR UNLOCK SWITCH SUB-ASSEMBLY (w/ Power Door Lock)

a.
B284623E01
2.113,0.14 2.277,0.294 0.164,0.154 10 *b 2.74,0.14 2.904,0.294 0.164,0.154 10 *c 1.213,0.618 1.329,0.772 0.115,0.154 10 E 0.582,0.251 0.787,0.404 0.206,0.154 10 UL 1.16,0.152 1.261,0.305 0.101,0.154 10 L 0.076,0.064 0.240,0.218 0.164,0.154 10 *a 0.721,0.957 1.17,0.712 false 0.542,0.955 1.124,0.233 false 0.405,0.956 0.548,0.333 false

Check the resistance.

Text in Illustration
*a Component without harness connected
(Door Unlock Switch Sub-assembly)
*b UNLOCK
*c LOCK

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 (L) - 4 (E) LOCK 10 kΩ or higher
OFF Below 1 Ω
2 (UL) - 4 (E) UNLOCK 10 kΩ or higher
OFF Below 1 Ω


If the result is not as specified, replace the door unlock switch.