Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR SUPPORT
RM19S0E _59 Vehicle Exterior _051502 DOOR / HATCH _0248396 BACK DOOR SUPPORT A

DOOR / HATCH  BACK DOOR SUPPORT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 68948 1.INSTALL BACK DOOR DAMPER STAY LOWER BRACKET

a.

Clean the threaded portion on the vehicle body with a non-residue solvent.


b.

Apply adhesive to the threads of the 2 bolts.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



c.

Install the back door damper stay lower bracket with the 2 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 68946 2.INSTALL BACK DOOR DAMPER STAY UPPER BRACKET

a.

Clean the threaded portion on the vehicle body with a non-residue solvent.


b.

Apply adhesive to the threads of the 2 bolts.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



c.

Install the back door damper stay upper bracket with the 2 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 68960 3.INSTALL BACK DOOR STAY ASSEMBLY

B271659

NOTICE:
·

Avoid touching the stroke portions of the rod as much as possible to prevent foreign matter from attaching to the stroke portions. Be sure to hold the cylinders while servicing.

·

Do not wear cotton gloves or other similar materials when handling the rod. Fibers may attach to the rod and result in gas leaks.

·

Do not apply any load to the cylinders in the horizontal direction, in order to prevent the rod from being deformed.



a.

Install the back door stay on the 2 ball joints.

NOTICE:

Install the back door stay while supporting the back door by hand.



b.

Engage the 2 stop rings.