Centering bolts are used to mount the hood hinge and the hood lock. The hood and the hood lock cannot be adjusted with the centering bolts in. Substitute standard bolts (with washers) for the centering bolts when making adjustments.
| *1 | Centering Bolt |
| *2 | Standard Bolt |
53301
1.ADJUST HOOD SUB-ASSEMBLY
Loosen the 4 hood side hinge bolts.
Move the hood to adjust the clearance to within the standard range (See page Vehicle Exterior>DOOR / HATCH>HOOD>ON-VEHICLE INSPECTION).
Tighten the 4 hood side hinge bolts after the adjustment.
Adjust the height of the hood front end by turning the 2 center hood cushions (See page Vehicle Exterior>DOOR / HATCH>HOOD>ON-VEHICLE INSPECTION).
The center hood cushion can be raised and lowered by turning it.
Adjust the hood lock.
Loosen the 3 bolts.
Adjust the hood lock position so that the striker can enter it smoothly (See page Vehicle Exterior>DOOR / HATCH>HOOD>ON-VEHICLE INSPECTION).
Tighten the 3 bolts after the adjustment.