Home › Vehicle Exterior › MIRROR (EXT) › OUTER MIRROR SWITCH
RM19S0E _59 Vehicle Exterior _051503 MIRROR (EXT) _0248403 OUTER MIRROR SWITCH G

MIRROR (EXT)  OUTER MIRROR SWITCH  INSPECTION  


PROCEDURE

Hide 84870A 1.INSPECT OUTER MIRROR SWITCH ASSEMBLY

a.
B127217E04
2.979,0.692 3.163,0.859 0.184,0.166 10 *1 0.771,4.296 0.889,4.442 0.118,0.145 10 B 1.033,4.296 1.151,4.442 0.118,0.145 10 E 1.282,4.296 1.503,4.444 0.221,0.148 10 M+ 1.619,4.296 1.825,4.444 0.206,0.148 10 HL 1.914,4.296 2.112,4.444 0.198,0.148 10 VL 2.23,4.296 2.441,4.444 0.211,0.148 10 VR 2.586,4.296 2.812,4.444 0.226,0.148 10 HR 1.296,3.904 0.828,4.279 false 1.436,3.906 1.109,4.264 false 1.597,3.909 1.427,4.261 false 1.742,3.906 1.742,4.255 false 1.896,3.91 2.004,4.262 false 2.051,3.907 2.343,4.256 false 2.205,3.907 2.67,4.262 false 0.292,2.948 0.448,3.129 0.156,0.181 10 *a 2.945,0.775 2.151,0.775 false 3.051,2.002 3.234,2.168 0.184,0.166 10 *2 3.017,2.085 2.222,2.085 false

Check the resistance.

Text in Illustration
*1 Left / Right Select Switch
*2 Adjustment Switch
*a Component without harness connected
(Outer Mirror Switch Assembly)

i.

Select "L" on the left/right select switch.


ii.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
4 (VL) - 8 (B)
6 (M+) - 7 (E)
UP Pressed Below 1 Ω
Not pressed 10 kΩ or higher
4 (VL) - 7 (E)
6 (M+) - 8 (B)
DOWN Pressed Below 1 Ω
Not pressed 10 kΩ or higher
5 (HL) - 8 (B)
6 (M+) - 7 (E)
LEFT Pressed Below 1 Ω
Not pressed 10 kΩ or higher
5 (HL) - 7 (E)
6 (M+) - 8 (B)
RIGHT Pressed Below 1 Ω
Not pressed 10 kΩ or higher


If the result is not as specified, replace the outer mirror switch.


iii.

Select "R" on the left/right select switch.


iv.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 (VR) - 8 (B)
6 (M+) - 7 (E)
UP Pressed Below 1 Ω
Not pressed 10 kΩ or higher
3 (VR) - 7 (E)
6 (M+) - 8 (B)
DOWN Pressed Below 1 Ω
Not pressed 10 kΩ or higher
2 (HR) - 8 (B)
6 (M+) - 7 (E)
LEFT Pressed Below 1 Ω
Not pressed 10 kΩ or higher
2 (HR) - 7 (E)
6 (M+) - 8 (B)
RIGHT Pressed Below 1 Ω
Not pressed 10 kΩ or higher


If the result is not as specified, replace the outer mirror switch.