85310
1.INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
Disconnect the windshield washer motor and pump connector.
The check should be performed with the windshield washer motor and pump installed on the washer jar.
Fill the washer jar with washer fluid.
Check to ensure that the windshield washer motor and pump operates when the battery voltage is applied between the terminals.
| *a | Component without harness connected
(Windshield Washer Motor and Pump Assembly) |
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 1
Battery negative (-) → 2 |
Washer fluid flows from the washer jar. |
If the result is not as specified, replace the windshield washer motor and pump assembly.