Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR(for Rear Side)
RM19S0E _59 Vehicle Exterior _051504 WIPER / WASHER _0248411 WASHER MOTOR(for Rear Side) G

WIPER / WASHER  WASHER MOTOR(for Rear Side)  INSPECTION  


PROCEDURE

Hide 85330F 1.INSPECT REAR WASHER MOTOR AND PUMP ASSEMBLY

a.

Disconnect the rear washer motor and pump connector.

HINT:

The check should be performed with the rear washer motor and pump installed on the washer jar.



b.

Fill the washer jar with washer fluid.


c.
E140350E07
0.288,0.238 0.468,0.376 0.180,0.139 10 *a

Check to ensure that the rear washer motor and pump operates when the battery voltage is applied between the terminals.

Text in Illustration
*a Component without harness connected
(Rear Washer Motor and Pump Assembly)

Specified Condition:
Measurement Condition Specified Condition
Battery positive (+) → 1
Battery negative (-) → 2
Washer fluid flows from the washer jar.


If the result is not as specified, replace the rear washer motor and pump assembly.