Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE(for Front Side) › from 2014.07
RM19S0E _59 Vehicle Exterior _051504 WIPER / WASHER _0248412 WASHER NOZZLE(for Front Side) G

WIPER / WASHER  WASHER NOZZLE(for Front Side)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85035 1.INSPECT WASHER NOZZLE SUB-ASSEMBLY

a.

With the engine running, check where the washer fluid hits the windshield.

E299300E01
3.327,2.459 3.496,2.641 0.170,0.181 10 A 3.649,2.417 3.819,2.599 0.170,0.181 10 B 4.041,2.487 4.211,2.669 0.170,0.181 10 C 4.209,2.926 4.379,3.108 0.170,0.181 10 D

Standard:
Area Measurement Area Measurement
A 75 mm (2.95 in.) C 36 mm (1.41 in.)
B 140 mm (5.51 in.) D 14 mm (0.551 in.)


OK:

Washer fluid hits the windshield in the areas as shown in the illustration.


If the result is not as specified, adjust the washer nozzle sub-assembly.