CUSTOMIZE LIGHTING SYSTEM (EXT)
The following items can be customized.
When the customer requests a change in a function, first make sure that the function can be customized.
Record the current settings before customizing.
Customizing with the intelligent tester.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Utility / Customize / Light Control.
Select the setting by referring to the table below.
| Display | Default | Content | Setting | Relevant ECU |
|---|---|---|---|---|
| Response Time*1 | Normal | Changes the delay timing of lighting the taillights when going into a tunnel when the headlight dimmer switch is in the AUTO position. | Normal or Long | Main body ECU |
| Sensitivity*1 | Normal | Adjusts the sensitivity of the automatic light control system*A. | Normal, Dark2, Dark1, Light1 or Light2 | Main body ECU |
| Disp Ex ON Sen*1 | Normal | Changes the ambient brightness level required to dim the lights such as the indicator lights*B. | Normal, Dark2, Dark1, Light1 or Light2 | Main body ECU |
| Disp Ex OFF Sen*1 | Normal | Changes the ambient brightness level required to cancel the dimming of the lights such as the indicator lights*C. | Normal, Dark2, Dark1, Light1 or Light2 | Main body ECU |
*1: w/ Automatic Light Control System
The sensitivity adjustment may be difficult to confirm. Check by driving the customer's vehicle.