Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
81108
1.REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY (for LED Headlight)
Turn the back cover in the direction indicated by the arrow shown in the illustration to remove it.
Disconnect the connector.
Remove the 2 screws and headlight control ECU sub-assembly.
Remove the headlight cover gasket from the back cover.
81110B
2.REMOVE NO. 1 HEADLIGHT BULB (for Halogen Headlight)
Remove the socket cover.
Release the set spring in the direction indicated by the arrow in the order shown in the illustration.
Remove the No. 1 headlight bulb.
Do not touch the No. 1 headlight bulb glass.
81110B
3.REMOVE NO. 1 HEADLIGHT BULB (for LED Headlight)
Turn the socket cover in the direction indicated by the arrow shown in the illustration to remove it.
Disconnect the connector.
Turn the No. 1 headlight bulb in the direction indicated by the arrow shown in the illustration to remove it.
Do not touch the No. 1 headlight bulb glass.
Remove the headlight gasket from the socket cover.
81610F
4.REMOVE CLEARANCE LIGHT BULB (for Halogen Headlight)
Turn the clearance light socket with the clearance light bulb in the direction indicated by the arrow shown in the illustration to remove them as a unit.
Remove the clearance light bulb from the clearance light socket.
81610F
5.REMOVE CLEARANCE LIGHT BULB (for LED Headlight)
Turn the clearance light socket with the clearance light bulb in the direction indicated by the arrow shown in the illustration to remove them as a unit.
Remove the clearance light bulb from the clearance light socket.
81510C
6.REMOVE FRONT TURN SIGNAL LIGHT BULB (for Halogen Headlight)
Turn the front turn signal light socket with the front turn signal light bulb in the direction indicated by the arrow shown in the illustration to remove them as a unit.
Remove the front turn signal light bulb from the front turn signal light socket.
81510C
7.REMOVE FRONT TURN SIGNAL LIGHT BULB (for LED Headlight)
Disengage the claw and clamp to disconnect the connector.
Turn the front turn signal light socket with the front turn signal light bulb in the direction indicated by the arrow shown in the illustration to remove them as a unit.
Remove the front turn signal light bulb from the front turn signal light socket.
85662
8.REMOVE HEADLIGHT LEVELING MOTOR (for LED Headlight)
Remove the screw and stopper.
Turn the headlight leveling motor in the direction indicated by the arrow (1) shown in the illustration to release it.
| *a | Aiming Screw |
When removing the headlight leveling motor of the headlight assembly RH, turn the headlight leveling motor in the opposite direction indicated by the arrow (1) shown in the illustration.
Turn the aiming screw of the headlight leveling motor in the direction indicated by the arrow (2) shown in the illustration to disengage the shaft.
Remove the headlight leveling motor.
85669
9.REMOVE HEADLIGHT LEVELING MOTOR BASE PACKING
Remove the headlight leveling motor base packing from the headlight leveling motor.